ZAPRAWA ZBK-012 SZARA is a thin-layer gray mortar used for building walls made of blocks, shapes and other elements made of aerated concrete and aerated concrete, joint thickness from 2 mm to 8 mm. The mortar is also useful during masonry work for building walls of bricks, hollow bricks and other similar ceramic, concrete or lime-sand materials. The mortar can also be used for leveling and filling surfaces with a layer thickness of approximately 3 mm.
The mortar is frost and water resistant, for indoor and outdoor use.
- used to connect elements with thin welds,
- prevents the formation of bridges at joints between wall elements,
- joint thickness 2 mm / 8 mm,
- easy to use,
ZAPRAWA ZBK-012 SZARA - thin-layer gray mortar is a ready-made dry mixture of cement and high-quality minerals. It has excellent adhesion to various types of construction substrates, especially aerated concrete and aerated concrete.
IMPORTANT INFORMATION:
- Mixing proportions: 5.50 – 6.25 L of water per 25 kg of mortar,
- Layer thickness: 2 mm – 8 mm,
- Grain size (maximum): 0.5 mm,
- Application temperature: +5°C to +28°C,
- Waterproof,
- Frost-resistant,
- For use: outdoor / indoor,
- Shelf life: 12 months,
SUBSTRATE PREPARATION:
ZAPRAWA ZBK-012 SZARA - a thin-layer gray mortar used on clean and dry surfaces of aerated concrete blocks and tiles. When leveling or filling the surface, it should be dry, stable, even and load-bearing. Excessive absorbency of the substrate before filling should be reduced by using AKRYL GRUNT GRUNTEX priming emulsion .
MORTAR PREPARATION:
The mortar is prepared by pouring the dry mixture into a container with 5.50 - 6.25 liters of water and mixing until a uniform mass is obtained. This operation is best performed mechanically, using a drill with a mixer. The mortar is ready for use after 5 minutes and after re-mixing. The prepared mortar should be used within approximately 4 hours.
HOW TO USE:
ZAPRAWA ZBK-012 SZARA - the thin-layer gray mortar should be spread evenly, using a notched trowel, on the surfaces of the aerated concrete blocks, then place the glued element and press it, checking its correct positioning. The joint thickness should be from 2 mm to 8 mm. Full strength of the joint is achieved after 3 days.
TOOLS:
Drill with mixer, notched trowel, trowel, spatula. Tools should be cleaned with clean water immediately after use.
RECOMMENDATIONS:
The manual specifies the scope of use of the product and the recommended method of performing the work, but cannot replace the professional preparation of the contractor. The manufacturer guarantees the quality of the product, but has no influence on the conditions and method of its use.
ATTENTION:
The mortar contains cement. Protect eyes and skin. If the eye is blocked, rinse with plenty of water.
STORAGE AND TRANSPORT:
The mortar should be transported and stored in tightly closed bags, in dry conditions, preferably on pallets.
Protect from moisture.
SHELF PERIOD:
12 months from the production date indicated on the packaging.
PACKAGING:
25 kg, bag
PALETTE:
25 kg x 48 bags = 1200 kg,
