FLOORING MORTAR ZP-07 is intended for making floor screeds with a thickness of 20 mm to 60 mm. Used on concrete, cement and anhydrite substrates - in residential and general construction, outside and inside the building.
• For all substrates based on hydraulic binders and insulation,
• Layer thickness: 20 mm / 60 mm,
• After mixing with water, it forms a homogeneous mass,
• Easy to spread,
• High durability,
IMPORTANT INFORMATION:
Application temperature: +5°C to +28°C,
Mixture proportions: approximately 3.5 L of water per 25 kg of mortar,
Foot traffic after: 48 hours,
Compressive strength: HIGH
Waterproof: YES
Frost resistance: YES
For use: outdoor / indoor,
Shelf life: 12 months,
PROPERTIES:
ZP-07 FLOOR MORTAR is frost and waterproof. The factory-prepared floor mortar mixture is produced on the basis of mineral binders and enriching additives that improve workability and ease of installation.
SUBSTRATE PREPARATION:
The substrate for ZP-07 FLOORING MORTAR should be strong, stable, clean of dust, dirt and poorly adhering parts, remnants of old paints, oils, lime and other substances. bitumen and other substances that may weaken the adhesion of the mortar. Moisten the substrate before applying the mortar. Prime absorbent substrates with a primer AKRYL PRIMER STRONGER.
MORTAR PREPARATION:
Pour the contents of the bag (25 kg) into a container with approximately 3.5 liters of water and mix manually or mechanically using a low-speed drill with a mixer until a uniform mixture is obtained.
TOOLS:
A drill with a mixer, a trowel, a smooth steel trowel, a Styrofoam or felt trowel. Tools should be cleaned with clean water immediately after use.
EXECUTION:
Spread the prepared mortar on the substrate between leveled battens or pipes, and then level it by troweling. The minimum thickness of a single layer is 20 mm when combined with the base layer, 35 mm when placed on the separating layer and 40 mm in floating floor structures. Protect the poured floor against too rapid drying, sunlight, low air humidity and drafts. Use (entering) is possible 48 hours after finishing laying the screed.
TECHNICAL DATA:
- Initial setting time approximately 3 to 5 minutes,
- Wear time up to 1 hour,
- Minimum layer thickness - 20 mm,
- Maximum layer thickness - 60 mm,
MIXTURE PROPORTIONS:
approximately 0.14 L of water per 1 kg of mortar,
about 3.5 L of water per 25 kg of mortar,
Substrate temperature during application from +5°C to +28°C.
RECOMMENDATIONS:
The instructions specify the scope of use of the product and the recommended method of performing the work, but cannot replace the professional preparation of the contractor. The manufacturer guarantees the quality of the product, but has no influence on the conditions and method of its use.
COMMENTS:
The mortar contains cement. With water it gives an alkaline reaction. Protect eyes and skin. If the eye is blocked, rinse with plenty of water.
STORAGE AND TRANSPORT:
Store in the original closed packaging in a dry place on pallets.
Protect from moisture.
SHELF PERIOD:
12 months from the production date indicated on the packaging.
PACKAGING:
25 kg, bag
PALETTE:
25 kg x 48 bags = 1200 kg. PALETTE
