STYRAMIK THS-04G adhesive mortar for gluing polystyrene boards on typical mineral substrates such as bricks, traditional cement or cement-lime plasters, concrete, aerated concrete. STYRAMIK THS-04G adhesive mortar can be used to fill small gaps.
• Reinforced with microfibers,
• Reinforced structure,
• Easy to use,
• Economical to use,
PROPERTIES:
STYRAMIK THS-04G adhesive mortar is a dry mixture of high-quality cement, minerals and polymers, thanks to which it has high vapor permeability, high efficiency, is easy and convenient to apply to walls, making it perfect for gluing polystyrene boards. STYRAMIK THS-04G adhesive mortar can be used both outside and inside the building.
IMPORTANT INFORMATION:
- Consumption: approximately 3.3 to 5.0 kg/m2,
- Mixing proportions: 5.0 – 6.0 L of water per 25 kg of mortar,
- Application temperature: +5°C to +28°C,
- Shelf life: 12 months,
MIXTURE PROPORTIONS:
Pour the dry adhesive mortar mixture into approximately 5-6 L of water and mix thoroughly manually or mechanically until a homogeneous mixture is obtained. The adhesive is ready for use after 5 minutes and re-mixing. STYRAMIK THS-04G adhesive mortar should be used within 2-3 hours.
EXECUTION:
Work should be carried out at temperatures from +5°C to +28°C. The substrate on which STYRAMIK THS-04G adhesive mortar is used should be dry, clean, and free from grease, paint residues and other paint coatings. Highly absorbent substrates should be primed with AKRYL GRUNT STRONGER. In case of gluing to difficult or unstable substrates, an adhesion test should be performed. The STYRAMIK THS-04G adhesive mortar should be applied to the Styrofoam board using a 10-12 mm notched trowel. The mortar should be spread over the entire board surface or along the edge of the board and in the form of 6-8 patches placed on the board surface. Immediately after applying the adhesive, place the board on the substrate and press it into the desired shape. Select the amount of mortar so that after tapping at least 60% of the board surface is glued. After the mortar dries, attach the polystyrene boards with plastic connectors.
